Lian Li Launches SUP-01 Side-Panel Case with Unique Features
TapTechNews May 30th news, Lian Li officially launched the SUP-01 tempered glass side-panel case today. One of the notable features of this case is its support for vertical graphics card installation on the front panel.
The SUP-01 case has a volume of approximately 45 liters and a footprint of 16.03 * 8.34 inches (403.45 * 212 mm), which is smaller compared to traditional tower cases. This case supports up to standard ATX motherboards and also ATX back-panel plug-in motherboards.
The case is compatible with CPU coolers up to 3.47 inches (88.2 mm) tall and power supplies up to 8.66 inches (220 mm) long.
It can install a 4-slot thick, 15.75-inch (400 mm) long graphics card via the included PCIe Gen4 riser card on the front panel; of course, it can also install a half-height add-on card in the usual position.
The SUP-01 case adopts a three-compartment design, including the power supply compartment at the bottom, the main compartment on the upper left, and the cooling compartment on the upper right (TapTechNews note: that is, behind the motherboard).
In the cooling compartment, next to the graphics card installation position on the front panel, the SUP-01 case pre-installs three 120-mm fans, which can enhance the cooling effect of the graphics card.
The fan parameters equipped by Lian Li for this case are as follows: the speed range is 300 to 1800 RPM, the maximum static pressure is 0.1 inches of water column (2.56 mmH2O), and the maximum air volume is 68.88 CFM.
In the rear position of the cooling compartment, the SUP-01 case has a 360/280 fan position for the CPU radiator.
In terms of storage, the SUP-01 case contains a 2-in-1 bracket that supports 2.5/3.5-inch hard drives in the power supply compartment, and there are also two 2.5-inch hard drive positions at the bottom of the main compartment.
Lian Li configures an RGB light strip on the lower part of the case shell, and the graphics card riser card also has RGB lighting effects and supports 6 preset RGB lighting modes.
In the IO design of this case, Lian Li cleverly uses the front LIANLI trademark as the power-on and restart buttons.
The main IO of the SUP-01 case is located on the left side and includes one USB Type-C 10 Gbps interface, two USB Type-A 5 Gbps interfaces, and a 2-in-1 audio jack.